Transducer Accessories

Replacement Fairing Block for GT56 Thru-Hull TransducersUse our fairing block to position your GT56 series of thru-hull scanning transducers parallel to the water line for increased sonar accuracy. If the deadrise angle of your mounting location exceeds...

Transducer Mounting PlateFeatures:Marine-grade polymer plate will not warp or corrodePremium materials; unaffected by UV raysMounts easily with only 2 screwsAll hardware included

MM-HB Mix & Match™ Cable 5-Pin 600W Series with Humminbird #9 Connector - 9MSpecifications:Sensor Connector: MMDisplay Connector: HBMix and Match Series: 5-Pin 600 WattCountry of Origin: USACable-Length: 9 m (30')

Hydrodynamic Fairing Block for CB101 Series TransducersEchonautics fairing blocks are made for the thru-hull installation of traditional stem transducers. A fairing block is recommended for the installation of any traditional stem transducers to the...

Hydrodynamic Fairing Block for CB131 Series TransducersEchonautics fairing blocks are made for the thru-hull installation of traditional stem transducers. A fairing block is recommended for the installation of any traditional stem transducers to the...

Large Nose Cone - GT56 Transducer CompatibleReplace the standard part of your compatible trolling motors or use the nose cone to install a compatible Garmin GT56 model transducer. If you’re rerouting a new transducer through the trolling motor...

Paddle WheelReplace your paddle wheel without having to replace the entire transducer. This kit includes the paddle wheel and the paddle wheel shaft.

MEGA Live 2 Transom Mount BracketThe MEGA Live 2 Transom Mount expands the versatility of MEGA Live 2, allowing anglers to install the transducer on the back of the boat, like traditional 2D, Down Imaging, and Side Imaging transom mount sonar. It’s...

Heavy Duty Transducer Extension Cable - 30' - 8-PinExtend the length of a compatible 8-pin transducer with this 30-foot cable.

Heavy Duty Transducer Extension Cable - 10' - 8-PinExtend the length of a compatible 8-pin transducer with this 10-foot cable.

GT17M-THF Galvanic Isolator KitUse this to replace the galvanic isolation parts included with the GT17M-THF transducer.

GT17M-THF Replacement Jam NutUse this stainless steel transducer jam nut on a compatible GT17M-THF transducer.