Installation Accessories

BEP Z Bar 18 Way Buss BarModel: 777-Z18W-200Easily extend Z-Bars by placing on end or back-to-backClean installation-all cables can be run from one side of the Z-barInnovative clear covers insulate and protect on three sides and offer easy accessThis...

Weld Mount AT-300 Adhesive Dispensing GunModel: 80300The AT-300 Adhesive dispensing gun has a 1:1 plunger for use with AT-2010 and AT-4020 50ml cartridges. When using AT-6030 adhesive it requires AT-12 (10 to 1 plunger). Replacement plungers are also...

BEP Temperature Sensor for Smart Battery HubModel: 80716003200BEP’s innovative Smart Battery Hub (SBH) is a world-first intelligent battery management system for vessels running two or more outboards, sterndrives, or multiple inboard engines. Smart...

Waterproof Junction Boxes Ideal for making wiring connections above or below decks, even in areas subject to occasional spray Similar to BX Series junction boxes, but made from rugged, non-corrosive, high impact polypropylene Snap-on cover provides...

Blue Sea 2126 MaxiBus 250A BusBar - Six 5/16"-18 StudsModel: 2126-BSSInsert molded stainless steel studs eliminate need for securing nut and allow high torquing for excellent electrical contactRaised bus provides easy access to multiple wires on a single...

Well Mount AT-5 Black Nylon Wire Tie Mount 100 PackModel: 805900BThe AT-5 tie mount is designed to be set into wet resin during the hull lay up or bonded with our acrylic adhesives. It's designed for a #5 wire tie and has an average pull strength of 150...

Weld Mount AT-5 White Nylon Wire Tie Mount 100 PackModel: 805900The AT-5 tie mount is designed to be set into wet resin during the hull lay up or bonded with our acrylic adhesives. It's designed for a #5 wire tie and has an average pull strength of 150...

RA Series Right Angle Waterproof Feed-Thru Fittings Route cables at 90° through vertical and horizontal surfaces with wall hugging low profile design that keeps cable secured close to the surface reducing intrusion with personnel or other equipment...

Blue Sea MaxiBus 250A BusBar - Two 5/16"-18 Studs and Twelve #10-24 ScrewsModel: 2105-BSSInsert molded stainless steel studs eliminate need for securing nut and allow high torquing for excellent electrical contactRaised bus provides easy access to...

Waterproof Junction Boxes Ideal for making wiring connections above or below decks, even in areas subject to occasional spray Similar to BX Series junction boxes, but made from rugged, non-corrosive, high impact polypropylene Snap-on cover provides...

BEP 702-2S Distribution Studs Dual Distribution Stud Module, 2 x 3/8" Model: 702-2S UPC: 870216000985 The 702-2S was designed specifically for transom areas for connecting battery cables from outboards. It also has many other applications where heavy...

Weld Mount AT-3 White Nylon Wire Tie Mount 100 PackModel: 803900The AT-3 tie mount is smaller for panel and other small space applications. This part is molded in white nylon and is sized for a #3 wire tie with a maximum width of .20". Average pull...